Lathem 2000 Manuale Utente Scaricare il pdf (Pagina 13)

Mechanical Time Recorder User’s Guide

Page 12

Install / Replace Batteries in BATT

Figure 9

The 2000-BATT requires four “D” size batteries and should

operate for six months before replacement. An internal

beeper sounds momentarily each minute when the battery

supply discharges below 4.5 volts. Replace batteries as

follows when this occurs:

1. Pull and remove the front two rubber feet underneath the

unit.

2. Loosen, 1 to 2 turns, the two phillips-head screws located

1.5 inches directly inside the rubber feet mounting holes.

3. Slide the bottom battery compartment outward (to front)

and down, to get to the batteries. (See Figure 9.)

4. Replace the four “D” size batteries. Be sure the batteries

are installed with proper polarity (+/-) as marked on battery

holder.

5. Re-install the battery compartment on the bottom of the

recorder, aligning the holes with the screws. Press the

compartment firmly to the back (inward), tighten the two

Phillips-head screws, and re-insert the two rubber feet.

1 2 ... 8 9 10 11 12 13 14 15 16 17

Nessun commento

Lathem 2000 Manuale Utente Pagina 13